Version history for DLG
2.3.0 - 26 April 2023 - download for OpenTx v. 2.2.2+
- To exit Zoom mode, can now pull elevator stick back as well as forward. Reduced threshold from 25% to 10% (changes in logical switch LS13).
2.2.0 - 15 November 2022 - download for OpenTx v. 2.2.2+
- On exiting Zoom mode, brakes are suppressed until brake stick is at idle. While brakes are suppressed, an alert sounds and the next lower priority flight mode is activated.
2.1.0 - 27 June 2022 - download for OpenTx v. 2.2.2+
- Reduced delay when entering Zoom mode
- Aileron diff range extended to permit negative diff (more down than up)
- Camber offset can be set for Landing mode (for example, to avoid camber 'jump' when going from Thermal to Landing mode.)
- Superdiff (roll rate enhandment with brakes) reinstated
- Simpler reassignment of CAL submode switch
2.0.1 - 4 May 2022 - download for OpenTx v. 2.2.2+
- Fixed minor bug CAL mode not called if SA is up. L21 changed to "FM1 and !SA↓ "
2.0.0 - 5 December 2021 - download for OpenTx v. 2.2.2+
- Added second thermal flight mode 'Thermal_2'
- Removed continuously variable camber option (not necessary with extra thermal FM).
- Camber in each flight mode is set using throttle trim.
- With brakes deployed:
- Zero-brake trim ('base trim') is derived from Cruise mode
- Full-brake trim ('compensation') is adjusted via repurposed elevator trim.
- Removed 'super diff' option
1.3.0 - 2 June 2021 - download for OpenTx v. 2.2.1+
- Fixed launch height callout timed from start (instead of end) of Zoom mode
- Added 'super diff' option for enhanced roll response under braking
- Launch height callout suppressed if in Launch or Zoom mode
1.2.0 - 11 May 2021 - download for OpenTx v. 2.2.1+
- Camber presets now available on all flight modes
- Enhancements to (optional) variable camber
- Simpler configuration
- Camber range is unconstrained (end points can be +ve, -ve, or zero)
- Max camber/elev compensation defaults to +/-25%, for easier setup
- Max brake/elev compensation defaults to 60%, for easier setup
- Improved documentation
- Fixed: telemetry continuously resetting while launch button pressed.
1.1.0 - 14 April 2021 - download for OpenTx v. 2.2.1+
- Added launch height callout
- Improved documentation
1.0.0 - 6 April 2021 - download for OpenTx v. 2.2.1+
- First version